1-28 First-Time Power-Up and Test Print
When you empty a refill bottle into a reservoir, the green
LED will blink until you install the corresponding profiler.
Then the LED will turn off. Do not refill the inks until the
green LED illuminates again.
3. After all four inks and the cleaning solvent reservoirs are full,
press the Online/Offline key to display the Front Page screen.
4. From the Front Page screen, press the (Menu) key to enter
the menu system.
5. Press the ) key repeatedly to highlight Maintenance.
6. Press the (Menu In) key to display the Maintenance menu.
7. Press the ) key repeatedly to highlight Fill Service Station.
8. Press the (Menu In) key.
The solvent trough in the service station fills with solvent.
9. From the Maintenance Menu, press the ) key repeatedly to
highlight Fill Heads With Ink.
10. Press the (Menu In) key.
The printheads are filled with cleaning solvent, emptied,
and filled with ink. This process takes approximately 30
minutes and is fully automated. During this process, occa-
sionally check that the ink and cleaning fluid purged from
the printheads is draining into the service station’s excess
ink reservoir. If not, ensure that the drain tube is fully
attached to the reservoir (see page 1-18).
Load Media To load media in the printer for the first time, see “Loading Roll-
Fed Media” on page 3-14 for instructions. The printer ships with
a starter roll of media and a cardboard takeup core pre-loaded
on the spools.
Send a Test Print from
Server
1. Install and set up the RIP.
Refer to the Quick Start Guide for the ColorSpan print server,
or the manual that accompanies the third party RIP you will
be using.
2. Run the jet health routine to detect, recover, and replace
unrecoverable jets.
See “Checking Jet Health” on page 3-6 for instructions.
3. Send a test print from the ColorSpan server or RIP to the
printer, to verify your installation.
