A SERVICE OF

logo

6.
Remove the WWAN module (see
WWAN module on page 39).
7. Disconnect the hard drive connector cable from the system board (see
Hard drive on page 43).
8.
Remove the keyboard (see
Keyboard on page 46).
9. Disconnect the display panel cable from the system board (see
Display assembly on page 49).
10. Remove the top cover (see
Top cover on page 53).
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
SIM (see
SIM on page 33)
RTC battery (see
RTC battery on page 41)
Memory module (see
Memory module on page 45)
Power connector cable (see
Power connector cable on page 60)
Fan (see
Fan on page 61)
Heat sink (see
Heat sink on page 63)
Remove the system board:
1. Lift the left side of the system board (1) until it rests at an angle.
2. Remove the system board (2) by sliding it up and to the left at an angle.
Reverse this procedure to install the system board.
Component replacement procedures
59