A SERVICE OF

logo

PCH heat sink (see
PCH heat sink on page 82)
Processor (see
Processor on page 83)
Remove the system board:
1. Disconnect the following cables from the system board:
(1) Display panel cable
(2) Optical drive cable
(3) USB board cable
(4) Power connector cable
2.
Remove the PM 2.5 × 4.5 screw (1) that secures the system board to the base enclosure.
3. Lift the right side of the system board (2) until it rests at an angle.
4. Remove the system board (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.
76 Chapter 4 Removal and replacement procedures ENWW