
IP address
You can configure the IP address manually or automatically via DHCP, BootP, or AutoP.
Manual configuration
1. On the control-panel menu, press OK.
2. Use the Left arrow (
) or the Right arrow ( ) button to select Network config., and then press
OK.
3. Use the Left arrow (
) or the Right arrow ( ) button to select TCP/IP config, and then press
OK.
4. Use the Left arrow (
) or the Right arrow ( ) button to select Manual, and then press OK.
5. Press the Right arrow (
) button to increase the value for the first section of the IP address. Press
the Left arrow (
) button to decrease the value. When the value is correct, press OK. Repeat this
process for the other three sections of the IP address.
6. If the address is correct, use the Left arrow (
) or the Right arrow ( ) button to select Yes, and
then press OK. Repeat step 5 for the subnet mask and default gateway settings.
-or-
If the IP address is incorrect, use the Left arrow (
) or the Right arrow ( ) button to select No,
and then press OK. Repeat step 5 to establish the correct IP address, and then repeat step 5 for
the subnet mask and default gateway settings.
Automatic configuration
NOTE: Automatic is the default Network config. TCP/IP config setting.
1. On the control-panel menu, press OK.
2. Use the Left arrow (
) or the Right arrow ( ) button to select Network config., and then press
OK.
3. Use the Left arrow (
) or the Right arrow ( ) button to select TCP/IP config, and then press
OK.
4. Use the Left arrow (
) or the Right arrow ( ) button to select Automatic, and then press OK.
It might take several minutes before the automatic IP address is ready for use.
NOTE: To disable or enable specific automatic IP modes (such as BOOTP, DHCP, or AutoIP), use
the embedded Web server or HP ToolboxFX.
ENWW Configure the product on the network 39