:: Seite 28 von 29 :: Datenblatt zum Produkt HP ProLiant DL140 (G3) / 1.60G DC mit DC# 128191 ::
Fragen zu dem Produkt HP ProLiant DL140 (G3) / 1.60G DC? Kein Problem - wir helfen Ihnen per eMail (info@diskontcomputer.com) gerne weiter!
http://www.diskontcomputer.com/Systeme/Server/HP_ProLiant_DL140_(G3)___1.60G_DC_DC_128191.html
System Unit
Dimensions
(HxWxD)
(with feet)
1.70 x 16.78 x 26.62 in (4.32 x 42.62 x 67.62 cm)
Weight
(approximate)
35 lb
(15.87 kg)
Fully configured
Input Requirements
(per power supply)
Range Input Voltage
90 to 140 VAC/180 to 264 VAC
Normal Line Voltage
115 or 230 VAC
Line Frequency
47 to 63 Hz
Rated Input Current
load
7.31A at 115VAC, 3.6A at 230VAC
BTU Rating
BTU-Hr
2228
Power Supply Output
Power
(per power
supply)
Rated Steady-State
Power
653W
Maximum Peak Power
Temperature Range
Operating
50° to 95° F (10° to 35° C)
Shipping
-40° to 140° F (-40° to 60° C)
NOTE:
All temperature ratings shown are for sea level. An altitude derating of 1° C per 304.8 m
(1.8°F per 1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed. Upper operating
limit is 3,048m (10,000 ft) or 70 Kpa/10.1 psia. Upper non-operating limit is 9,144 m (30,000 ft) or
30.3KPa/4.4 psia. System performance may be reduced if operating above 30° C.
Relative Humidity
(non-condensing)
Operating
10% to 85%
Non-operating
10% to 95%
Acoustic Noise
Idle
(Fixed Disk Drives
Spinning)
L WAd
(BELS)
6.21
Operating
(Random Seeks to Fixed
Disks)
L WAd
(BELS)
6.29
Non-Hot Plug SATA
Hard Drives
80 GB 7.2K
383410-B21
Capacity
80027 MB
Height
1.028 in (2.61 cm)
Width
4.0 in (10.16 cm)
Interface
SATA 150
Transfer Rate
Synchronous
(Maximum)
150 MB/s
Seek Time
(typical reads, including
settling)
Single Track
0.8 ms
Average
9.0 ms
Full-Stroke
17.0 ms
Rotational Speed
7,200 rpm
Physical Configuration
Bytes/Sector
512
Logical Blocks
160,086,528
Operating Temperature
41° to 131° F (5° to 55° C)
QuickSpecs
HP ProLiant DL140 Generation 3 (G3)
Technical Specifications
DA - 12509 Worldwide — Version 14 — July 9, 2007
Page 28
