Display assembly
Description Spare part number
33.8-cm (13.3-in) HD LED BrightView display assembly 633279–001
Before removing the display assembly:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 34)
b. Keyboard (see
Keyboard on page 42)
c. Top cover (see
Top cover on page 45)
5. Disconnect the wireless antenna cables from the WLAN module (see
WLAN module
on page 55).
6. Disconnect the wireless antenna cables from the WWAN module (see
WWAN module
on page 57).
Remove the display assembly:
1. Turn the computer display-side up, with the front toward you.
2. Open the display as far as possible.
3. Disconnect the display panel cable (1) from the system board and remove it from its routing
channel.
Component replacement procedures 61
