Camera module
Description Spare part number
Camera module (includes flex cable) 494030-001
Before removing the camera module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 41)
b. Keyboard (see
Keyboard on page 55)
c. Switch cover (see
Switch cover on page 59)
d. Display (see
Display assembly on page 70)
Remove the camera module:
1. Loosen the tape (1) that secures the camera cable to the display enclosure.
2. Disconnect the camera flex cable from the camera board (2).
3. Use a flat-bladed screwdriver to loosen the camera module from the clips in the display enclosure,
and then pull the module and cable through the opening near the top of the enclosure (3).
76 Chapter 4 Removal and replacement procedures
