Configure Media 2-7
• If you pressed a media name, a list of settings appears
(see Fig. 2-1). From this screen you can change the
Media Settings, change the Print Mode, Select Media
again, or Proceed to loading the media. To load media,
press the ! (Proceed) key and go to “Load and Print on
Rigid Media” on page 2-10 or “Load and Print on Roll-Fed
Media” on page 2-15.
• If you pressed Create Media Type, the control panel
prompts you to press the ! (Proceed) key to create a
new media type, or ( (Cancel) to return to the Media
Wizard screen.
If you press the ! (Proceed) key, the control panel displays
an alphanumeric keyboard so you can enter a name for the
media you are creating.
3. Enter the media name, then press the Enter key to continue.
A list of default settings appears. To change any of the set-
tings, press the Media Settings key to display a menu of
settings you can change:
• Media Name
• Media Feed Method — Roll or Cut Sheet.
• Platen Vacuum Control — this option turns on the vac-
uum fans, and displays , and ) keys on the control
panel. Press , and ) to raise or lower the fan speed.
Fig. 2-1. Media settings screen
