22 Chapter 7—Use the copy features
HP PSC 700 Series
0DNHFRSLHV
You can make copies using the front panel of your unit or using your computer. All copy
features are available using either method.
All copy settings selected on the front panel are reset two minutes after the unit
completes the copy job unless you save the settings as the default settings. Settings that
you set in the software’s Copy dialog box are reset immediately after you process the
job. (Settings changed in the software’s Copy Settings dialog box remain in effect until
you change them again. For more information, see “Change settings for all future copy
jobs” in the Onscreen Guide.)
,QLWLDWHWKHFRS\SURFHVVIURP\RXU+3 36&
1 Load the input tray with the appropriate paper. Follow these steps to start a copy
job from your unit. If you are using anything other than plain paper, press Paper
Type until the appropriate type appears.
For more information, see “Load paper or transparency film, or load originals”.
2 Load your original.
For more information, see “Load originals on the glass”.
3 If you want to make more than one copy (the default), press Number of Copies, or
if number of copies is displayed, press or until the number of desired copies
appears.
For more information, see “Set the number of copies” in the Onscreen Guide.
4 Change any other applicable settings, such as Creative Copying.
5 Press Start Copy, Black or Color.
,QLWLDWHWKHFRS\SURFHVVIURP\RXUFRPSXWHU
Follow these steps to start a copy job from your computer.
1 Load the input tray with the appropriate paper.
For more information, see “Load paper or transparency film, or load originals”.
2 Load your original.
For more information, see “Load originals on the glass”.
3 In the Director, click COPY.
