Chapter 9 Remove/Replace Procedures
100
4. Repeat Step 3 for the three-remaining snap rivet housings and snap rivets.
5. Connect the chassis fan’s power connector.
6. If necessary, replace any accessory boards removed to allow clear access to the fan.
7. Replace the left side cover.
8. Replace the external cables and power cord.
9. Power on the Server as described in Chapter 2, “Controls, Ports, and Indicators.”
10. Verify the chassis fan is operating correctly.
System Board
Removing the System Board
1. If the Server is operating, power down the Server.
Refer to Chapter 2, “Controls, Ports, and Indicators” for instructions.
2. Disconnect the power cord and any external cables.
If necessary, label each one to expedite re-assembly.
3. Remove the left side cover.
4. Lay the Server on its side (components showing).
5. Remove any accessory boards mounted on the system board.
6. Disconnect all cables connected to the system board.
If necessary, label each one to expedite re-assembly.
7. Remove all the screws securing the system board to the chassis.
8. Slide the system board forward, releasing the rear panel connectors, and then lift the system board up
and away from the chassis.
9. Place the system board on an anti-static pad and record all jumper connections.
10. Remove DIMMs, heatsink-cooling fan and the processor, placing the components on an anti-static pad.
11. Place the system board in an anti-static container.
