**
4.3 Satellite Setting
This menu appears only when you enable Motorised System in Antenna Setting menu and press the OK button while Antenna
Alternative in Manual Search menu is selected.
**
• Satellite Name: Select a satellite to identify a motor antenna. If the desired satellite name is not listed, then select "OTHER".
• Movement: In user mode, this is used to fine-tune the position of the motor. In installer mode, this is used to search for the position
of the satellite manually.
• Motor Control: You can select one option among "Search", "Go to",
"Store", or "Reset".
**
- Search: Searches for services on the selected transponder.
- Go to: Moves the motor to the saved position of the selected satellite.
- Store: Saves the current position of the motor for the selected satellite.
- Reset: Resets all saved positions of the motor relative to the 0 position.
(Installer Mode Only)
• DiSEqC Command Mode: Select "Installer" or "User" mode.
**
The following table shows the value of the motor setting options.
**
DiSEqC Command Mode Movement Motor Control
Installer East / Stop / West Search / Go to / Store / Reset
User Stop(60E) ~Stop(0) ~Stop(60W) Search / Go to / Store
GB 18
