7
45034-01 • 10/23/08 • Hunter Fan Company
You can assemble your fan for standard or angled mounting as shown
in steps 4-1 – 4-6. For low profile mounting (ceilings less than 8 feet
high), go to steps 4-7 – 4-11 on the next page.
4-1. Unbundle the wires from the fan and remove the paper caution
tag. Do not discard the tag until your installation is complete.
4-2. To assemble fan to hang down from a at or angled ceiling,
insert the downrod through the canopy, adapter cover grommet,
adapter cover, and canopy trim ring. (e adapter cover and
adapter cover grommet may already be attached to make one
piece.) Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the dowrod.
4-3. Using the provided Allen wrench, loosen the setscrew on the
adapter to install the pipe and ball assembly. Note: When the
pipe and ball assembly is fully installed, 2-3 threads on the pipe
will still be visible; this is normal. Use the Allen wrench to securely
retighten the setscrew.
CAUTION: e adapter has a special coating on the threads.
Do not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
4-4. Attach the adapter cover to the top of the fan housing using a short
screwdriver.
4-5. Raise the fan and place the ball into the hanger bracket.
4-6. Align the notch on the ball with the indent in the hanger bracket.
(Rotate the fan until you hear the notch pop into place.)
Go to 5 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 4-4 – 4-5
Indent
Steps 4-1 – 4-3
Downrod
Canopy
Canopy
Trim
Ring
Set Screw
Adapter
Cover
Adapter
Cover
Grommet
4 • Assembling and Hanging the Fan
