28
41457-01 7/2000
®
INSTALLING INCLUDED ACCES-
SORY LIGHT FIXTURE GLOBES
AND BULBS
1. Place globe over threaded
lampholder in cup. Install and
hand tighten threaded locking
ring on lampholder as shown in
Figures 11c and 11d.
2. Install bulbs. Use 120V, 60W
maximum medium base incan-
descent bulbs. Turn power ON at
main panel.
Figure 11c - Installing the Globes
Cup
Threaded
Lamp Holder
Threaded
Locking Ring
Globe
Figure 11d - Assembling the Locking
Ring
Beginning of
First Thread
Threaded
Locking Ring
Notch in Ring
Note: As shown in Figure 11d,
line up the beginning of the first
thread on the lampholder and
notch on the locking ring to
avoid cross threading the ring.
If the ring becomes hard to turn,
rotate the ring counter clockwise
to loosen and reposition. Do not
force the ring on.
Note: Both plug connectors are
polarized and will only fit together
one way. Make sure that both
connectors are properly aligned
before connecting them together.
Incorrect connection could cause
improper operation and damage
to the product.
7. Place the lower switch housing
assembly over the upper switch
housing. Align the side screw
holes in the upper and lower
switch housings. Attach the lower
switch housing to the upper
switch housing with three #6-32
x 3/8" housing assembly screws.
See Figure 10e on page 25.
