Step 2
Step 3Steps 5-9
1. Disconnect power to the ceiling fan by turning off the circuit breakers
both to the outlet box and to its associated wall switch location.
2. Unscrew the fi nial to remove the fi nial and switch housing cap.
Note: Save the fi nial and switch housing cap should you choose to re-
move the light fi xture in the future.
3. Plug-in the light fi xture and turn the gear wheel to the right (clockwise) to
secure the light fi xture. WARNING: Improper installation could cause the
light fi xture to fall.
4. Install 2 - 60 W Max A-15 bulbs.
5. Attach the 8” extension chain to the fan pull chain. Attach the 4” exten-
sion chain to the light pull chain.
6. Snap the adapter into the hole in the glass bowl.
7. read the light pull chain through the center hole in the adapter, cap
and fi nial. read the fan pull chain through the side hole in the adapter
and cap.
8. Place the glass bowl and cap over the threaded rod.
9. Screw the fi nial onto the end of threaded rod to secure the glass bowl.
Note: If the glass bowl is crooked, you can loosen the fi nial and adjust the
glass bowl until it is level. Once level, securely tighten the fi nial.
10. Restore power to the ceiling fan.
Finial
Switch Housing
Cap
Light
Fixture
Gear
Wheel
Fan Pull
Chain
Light Pull
Chain
Adapter
Glass Bowl
Cap
Finial
readed Rod
41764-01_Rev 4-4-05.indd 3 4/4/05, 2:27:41 PM
