2-7
2. Printer Settings (20 ppm copier)
2-3 List of settings
Item No.
1
2
3
4
5
6
7
8
9
10
11
12
13
Item
Printer Status Page print out
Prints out a list of such items as printer
default settings and memory volume, etc.
Interface selection
When the optional Network Card is installed,
the available interfaces are displayed. The
arrow (>) will indicate the currently selected
interface. The printer will automatically
switch to the appropriate interface for
printing.
Parallel TX/RX mode
Sets the transmission and reception mode
when the printer is connected to your
computer with a parallel interface.
NetWare ON/OFF
NetWare frame type
Sets the NetWare frame type.
TCP/IP ON/OFF
DHCP ON/OFF
IP address
Subnet Mask
Gateway address
EtherTalk ON/OFF
Network Card Status Page print out ON/
OFF
Sets whether a Status Page regarding
conditions in the Network Card will be
printed out as well when the standard Status
Page for the printer (item No.: 1) or that for
use by your service representative (item No.:
60) are printed out. A more detailed Status
Page is printed out together with the
“Service Rep Status Page print out” setting
(item No.: 1).
Emulation protocol
Sets the emulation protocol that will be used.
Display message
Print Status Page
Interface
Parallel
NetWare
NetWare Frame
TCP/IP
DHCP
IP Address
Subnet Mask
Gateway
EtherTalk
Opt. StatusPage
Emulation
Available settings
No, Print
Parallel, Option
Auto, Normal,
High Speed,
Nibble (high)
On, Off
Auto, 802.3,
Ethernet II, 802.2,
802.3 SNAP
On, Off
On, Off
Enter the address.
Enter the address.
Enter the address.
On, Off
On, Off
Line Printer,
IBM Proprinter,
DIABLO 630,
EPSON LQ-850,
PCL 6, KPDL,
KPDL (AUTO)
Remarks
“Option” is displayed only when the
Network Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the NetWare
setting is turned “On”.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Displayed only when the Network
Card is installed.
Allows you to set a different
emulation for the parallel interface
and the Network Card (option).
Select the desired interface under
the “Interface selection” setting
(item No.: 2).
