Wired LAN
Wireless LAN
Network Restart
MAC Address
Previous
Execute
00:08:0C:04:10:48
( Network )
MDL: IN3128HD
FW: 0.10
28
Network
Allow you to configure the network settings.
Wired LAN
Status: Display
the projector’s status.
DHCP: Abbrev
iation for Dynamic Host Configuration Protocol. This
protocol automatically assigns IP Addresses to networked devices.
•When the “DHCP” is set to “On”, the DHCP server will assign an IP
address to the projector automatically. This may take up to a minute.
•When the "DHCP" is set to "Off", the user will need to set the IP
address manually.
IP Address: The numerical address used to identify devices on the net-
work. This is only accessible when DHCP
is set to Off.
• The IP Address is the number that identifies this projector on the
network. You cannot have two devices with the same IP Address on the
same network.
• The IP Address “0.0.0.0” is prohibited.
Subnet Mask: A numeric value defining the number of bits used in an IP
Address when the network is divided into subnets. This function can only
be used when DHCP is set to Off.
• The Subnet Mask “0.0.0.0” is prohibited.
Default Gateway: A server (or router) to communicate across networks
(subnets) that are divided by a Subnet Mask. This function can only be
used when DHCP is set to Off.
DNS: Setup DNS server
address when DHCP is disabled.
Apply: Save and execute the wired network settings.
Wireless LAN
Status: Display
the projector’s status.
SSID: Display the projector’s SSID information.
Connection Mode:
Methods for connecting to wireless networks with
Wi-Fi enabled devices.
IP Address: a read-only display of IP Address.
Network Restart: Restart
network settings.
MAC address:Abbreviation for Media Access Control Ad
dress. Mac Address
is a unique ID number assigned to each network adapter.
DC 12V Trigger
DC 12V Trigger: If this featur
e is enabled and you connect your projection
screen to this output using the cable that came with your screen, the screen will
move down when the lamp is turned on and the screen will return to its storage
position, when the lamp is turned off.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info: a read-only
display of current projector settings.
Reset Lamp Hours...:
resets the lamp hours used counter in the Projector Info
menu to zero. Do this only after changing the lamp.
Factory Reset...: restor
es all settings to their factory default settings.
Service Code...:
only used by authorized service personnel.
