VLAN Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 375
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a protocol-based classification rule of protocol group 1 to
VLAN 8.
map mac macs-group
Use the map mac macs-group VLAN configuration command to map a MAC address or
range of MAC addresses to a group of MAC addresses. Use the
no form of this command
to delete the map.
Syntax
map mac mac-address {prefix-mask | host} macs-group group
no map mac mac-address {prefix-mask | host}
Parameters
• mac-address - Specify MAC address to be entered to the group.
• prefix-mask - Mask bits. The format is “/n”, where n is an integer number that specifies the
number of 1’s in the mask.
• host - All 1’s mask.
• group - Group number
Default Configuration
This command has no default configuration.
Command Mode
VLAN Configuration mode
User Guidelines
There are no user guidelines for this command.
Console (config)# interface ethernet ext.8
Console (config-if)# switchport general map protocols-group 1 vlan 8
