Invacare R100 Manual

A SERVICE OF

next previous

INSTALLATION

Part No. 1145810 21 Electric Portable Patient Lift

Mounting the Battery Charger

NOTE:Forthisprocedure,refertoFIGURE 2.5.

NOTE:Refertoyourlocalregulationsconcerningpropermountingprocedures.

1. Placethebatterychargerwithmountingbracketonthewallatthedesiredposition.

2. Withapencil,markthemiddleholeposition.

3. Measuredown6½inchesfromthepencilmarkanddrillonemountinghole.

4. Installthebottommountingscrewuntilthereisanapproximate1/8‐inchgapbetween

thescrewheadandthewall.

5. Installthebatterychargerwithmountingbracketontothebottommountingscrew.

6. Drilltheremainingtwomountingholes.

7. Installthetworemainingmountingscrewsthroughthemountingbracketandintothe

wall.Tightensecurely.

8. Plugthebatterychargerintothewallelectricaloutlet.

9. VerifythatONisilluminated.

FIGURE 2.5 Mounting the Battery Charger

Mounting Bracket

Mounting

Screws

Battery Charger

with Mounting

Bracket

Bottom Mounting Screw