CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
0 Pin
Description
0
FCIS-1
RH FRONT SIDE LAMP SUPPLY
0 FC15-2
l.H FRONT Dl LAMP SUPPLY
0
FC15-3
RH FRONT DI LAMP SUPPLY
I FC15-14
HEADLAMP MNNBEAM REOUEST
1 FCIS-15
IGNITION SWITCHED GROUND
I FC15~16
SIDE LAMP REOUEST
0
FC15-20
FRONT FOG LAMP RELAY ACTIVATE
0 FC15~27
LH SIDE Di REPEATER LAMP SUPPLY ,ROW ONLY1
I FC15-30
HEADLAMP FLASH REOUEST
I FCi5-38
FRONT FOG LAMP REOUEST
I FC15-41
STARTER ENGAGE REWEST
I FC15-42
HEADLAMP DIP REOUEST
0
FC15-45
MAIN BEAM RELAYACTIVATE
0
FC15-53
LH FRONT SIDE LAMP SUPPLY
I FC1549
HAZARD LAMP REOUEST
I FC15-61
RH DI REOUEST
0 FC15-68
DIP BEAM RELAY ACTIVATE
I FC15-79
BArrERY SVPPLY VOLTAGE
I FC15-80
BATTERY SUPPLY VOLTAGE
0 FC15-81
RH SIDE DI REPEATER LAMP SUPPLY (ROW ONLY)
s FC15~84
SCP NETWORK
s
FC15-85
SCP NETWORK
I FC15-88
LH DI REOUEST
0 FCli-96
HAZARD LAMP STATUS
Active
Bi
B+ IPULSED)
B+ (PULSED1
GROUND
GROVND
GROUND
GROUND
B- (PULSEDI
GROUND ,MOMENTARY~
GROUND
GROUND (CRANKINGI
GROUND IMOMENTARY~
GROUND
B+
GROUND IMOMENTARY)
GROUND
GROUND
Bt
Bt
BL iP”LSEDi
2- 1600 HZ
2- 1600 Hz
GROUND
GROUND IPULSE,
INSTRUMENT PACK
‘;7 Pin
Description
Active
s FC24-19
SCP NETWORK
2- 1soo HZ
s FC24-20
SCP NETWORK
2- 1600 Hz
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
GROUND
GROUND
GROUND
Bi
Bc
BT
B+
GROUND
BT
B+
Bt
BA
B+
GROUND
B+
B+
*+
Bc
B+
GROUND
B+
Bt
Inactive
COMPONENTS
Component
Location / Access
BODY PROCESSOR MODULE
CENTER CONSOLE SWITCH PACK
DlRECTlON lND,CATOR LAMP- LH FRONT
DlRECTlON INDICATOR LAMP RH FRONT
FOG LAMP SWITCHES
FOG LAMP LH FRONT
FOG LAMP - RH FRONT
FRONT LAMP “NIT- LH
FRONT LAMP UNIT- RH
FUSE BOX-ENGINE COMPARTMENT
,NSTRUMENT PACK
UGHTING STALK iCOLUMN SWITCHGEAR
SiDE D, REPEATER - LH
S,DE DI REPEATER RH
Connector I Type I Color
FC,5,14-WAY AMP EEECiGREY
cc,, 16.WAY FORD IDC s u., BLACK
BE IZWAY RElNSHAGEN , VOLKSWAGEN /BLACK
BRZ, Z-WAY REINSHAGEN , VOLKSWAGEN, BLACK
FC3,10-WAY AMP MICRO OUAD LOCK, NATURAL
BL4,l~WAY DELPHI, PACKARD METRlPACK 280, GREY
BR~,~-WAY DELPHI, PACKARD METRIPACK 280 ,GREY
LS38, B-WAY AUGAT 1 5, BLACK
~9.0, B-WAY AUGAT 1.6 i BLACK
LS5,,0-WAY “.T A. FUSE BOX, NATURAL
LS6, ,&WAY U.T.A. FUSE BOX, BLACK
67, ,&WAY U T.A FUSE BOX, GREEN
LSB , l&WAY “.T A. FUSE BOX / BLUE
STiS, EYELET
FCZ4, &-WAY AMP MODULE PCB SIGNAL, BLACK
FCZS,Z4-WAY AMP MODULE PCB SIGNAL, BLACK
SC2,,0-WAY MULTILOCK 070 /YELLOW
LS17, S-WAY AMP JUNIOR POWER TlMER, BLACK
CA80 ,2-WAY AMP JUNIOR POWER TIMER, BLACK
BULKHEAD I BEHIND GLOVE BOX
CENTER CONSOLE SWITCH PACK
FRONT BUMPER - LH SDE
FRONT BUMPER - RH SIDE
FASW,, OUTBOARD OF STEERING COLUMN
FRONT BUMPER - LH SIDE
FRONT BUMPER - RH SIDE
ENGlNE COMPARTMENT, iH FRONT
ENGlNE COMPARTMENT, RH FRONT
ENGlNE COMPARTMENT, LH FRONT
FASCIA
COLUMN SWITCHGEAR HARNESS,
ADJACENT TO STEERING COLUMN MOTOR
BEHlND LEFT HAND WHEEL ARCH LINER
BEHlND RlGHT HAND WHEEL ARCH LINER
RELAYS
Relay
Case Color
Connector / Color
Location / Access
DIP BEAM RELAY
BROWN BUS
RELAY #S, ENGlNE COMPARTMENT FUSE BOX, ENGINE COMPARTMENT
FRONT FOG RELAY
BROWN
BUS
RELAY #2. ENGlNE COMPARTMENT FUSE BOX, ENGlNE COMPARTMENT
MAIN BEAM RELAY
BROWN BUS
RELAY $0, ENGlNE COMPARTMENT FUSE BOX, ENGINE COMPARTMENT
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color
Location I Access
BL1
I-WAYAUGAT ,.G,BLACK
BRI
a-WAY AUGAT 1.6, BLACK
FC5
54.WAYTHROUGH PANEL CONNECTOR, BLACK
FC7
20.WAY MULTILOCK 070, WHITE
LS3
54.WAY THROUGH PANEL CONNECTOR, BLACK
BEHlND LEFT HAND WHEEL ARCH LINER
ADJACENT TO BOSOM OF WASHER FLUID RESERVOIR
BELOW DRIVER SIDE AIR VENT, COIN TRAY
ABOVE DIMMER MODULE/COIN TRAY
LH ‘A’ POST, LOWER ‘A’ POST FINISHER
GROUNDS
Ground Location I Type
CA33R
cc3
ccm
FC17L
FCliR
LSISL
LS,SR
EYELET (PAIR) - RH ‘4’ POST GROUND SCREW
EYELET (PAIRI - RH FRONT BULKHEAD STUD, CABIN SIDE
EYELET (PAIR) - RH FRONT BULKHEAD STUD/CABIN SIDE
EYELET IPAIR) - EMS BULKHEAD GROUND STUD
EYELET IPAIR) - EMS BULKHEAD GROUND STUD
EYELET (PAIR) - LH FORWARD GROUND STUD
EYELET (PAIR, - RH FORWARD GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT
PAGE)
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications
B+ Battery voltage
KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC)
MS Milliseconds
SG Signal Ground
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation.
THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted.
“Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
