Safety Information
Electrical Safeguards
WARNING!!! High Voltage points up to 40,000 volts
are exposed inside the covers. Allow at least one minute for
the high voltage to bleed off, even after power is turned off.
High voltage access. Front
and rear covers contain
safety interlocks. Defeat
restricted to Hughes-JVC
certified service personnel!
Due to high voltage danger,
DO NOT TOUCH
• CRT cables. These cables can cause severe shock from a
tiny, invisible crack or hole and should never be touched
while projector power is on.
• CRT anodes.
• Main power ± supply posts.
• Arc Lamp main power ± posts.
• CRT yoke assemblies and other proximity electrical
assemblies, components and wiring. If performing the ILA
®
Back Focus, CRT Mechanical Focus, CRT rotation, or
ILA
®
Overlap adjustment, as outlined in Chapter 3, always
use an ANSI/ASTM 10,000 volt rated glove. Periodically
check the condition of the gloves for cracks.
Power Supply
The projector operates from a 100V - 240V, 20 Amp, single-
phase, 50/60 Hz AC power source. Ensure local power source
matches these requirements before operating!
For continued safe and reliable operation, only use cables
supplied by the manufacturer for power and signal connections.
Fluid Safeguards
Certain components of the projector contain fluid. If any fluid from
the projector contacts the skin, wash off with soap and water. If
any fluid from the projector splashes into the eyes, rinse with cool
running water.
Model 200 Service Manual
viii
