6
|
KDC-W237S
General Operation
Audio Control
1
Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item to adjust
Press the [VOL] knob.
Adjustment Item Display Range
Subwoofer level “SW L” –15 — +15
System Q “NATURAL”/
“ROCK”/“POPS”/
“EASY”/“TOP40”/
“JAZZ”/“USER”
Natural/Rock/Pops/Easy/Top
40/Jazz/User setting
Bass level “BAS L” –8 — +8
Middle level “MID L” –8 — +8
Treble level “TRE L” –8 — +8
Balance “BAL” Left 15 — Right 15
Fader “FAD” Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
⁄
• “USER”: This appears when Bass level, Middle level, and
Treble level are adjusted. When “USER” is selected,
these levels are recalled.
4 Adjust the Audio item
Turn the [VOL] knob.
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.
Audio Setup
Setting the Sound system.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Adjustment Item Display Range
Low Pass Filter “LPF” 80/120/160/Through Hz
Volume offset “V-OFF” –8 — ±0 (AUX: -8 — +8)
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
4 Adjust the Audio setup item
Turn the [VOL] knob.
5 Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
