22
Operations
Normal playback
Operations
Preparing for playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER( )
or SYS. POWER( ) key.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “MD/TAPE”.
2 Hold down the AUTO/CINEMA EQ. key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat procedure 2.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from the
subwoofer.
A+B ON : Sound from both the speakers connected to the SPEAKERS
A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when listening
with headphones for stereo sound in all playback modes.
Selecting the input mode
If you have selected a component connected to the CD/DVD,DVD/6ch
VIDEO2, or VIDEO3 jacks, make sure that the input mode setting is
correct for the type of audio signal to be used. 7
LFE
C
S
RSLS
TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
L
SP A
R
SW
B
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
The indicator for the speakers
you want to use should be lit.
• Selecting “6ch INPT” by pressing the INPUT MODE key, whereby
“DVD/6ch” is the input source will cause SPEAKERS A to be selected
automatically.
1
Listening to a source component
1 “PHONO”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
6 “VIDEO2”
7 “VIDEO3”
8 “DVD/6ch”
9 “AV AUX”
+
—
+
—
INPUT SELECTOR
VOLUME CONTROL
MUSIC
MOVIE
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.
Selecting a source using the MUSIC key
1 “CD/DVD”
2 “TAPE” or “MD”
3 “TUNER”
4 “PHONO”
1 “VIDEO1”
2 “VIDEO2”
3 “VIDEO3”
4 “DVD/6ch”
5 “AV AUX”
Selecting a source using the MOVIE key
• MUSIC and MOVIE will not display input sources which are not pre-
setup.
2
3
Start playback from the selected source.
Use the VOLUME CONTROL knob or VOL. +/– keys to
adjust the volume.
AUTO/CINEMA EQ.
INPUT MODE
POWER ( )
INPUT SELECTOR
SPEAKERS A/B
*509/22-23/EN 3/15/01, 2:03 PM22
