Rev. F 10/09
2
2084537
Rev. F 10/09
7
2084537
1. Tilt Fan Head back. Place Plastic Rear Grill on Motor.
(Figure 1)
2. Align tab of Plastic Rear Grill with groove on top of front
Motor cover.(Figure 2)
3. Fully seat Plastic Rear Grill and secure with Plastic Nut
turning CLOCKWISE. (Figure 3)
Figure 4A
Pin
Groove
4. Slide Blade onto motor shaft. (Figure 4) (Align Groove on
blade hub with Pin on motor shaft. Figure 4A)
Figure 4
Blade
Plastic Rear
Grill
Motor
Figure 2
Figure 1
Motor
Plastic Rear
Grill
Fan Head
Figure 3
Plastic Nut
Plastic Rear
Grill
ASSEMBLY
NOTES
standards relating to electrical requirements for Agricultural
Buildings. THIS HEATER DOES NOT MEET THE REQUIRE-
MENTS OF NEC ARTICLE 547-7 (2008).
16. This Fan is not suitable for use in hazardous locations. Please
refer to National Electric Code (NEC) Article 500 or applicable
state or local codes or standards relating to electrical
requirements for Hazardous locations. THIS FAN DOES
NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500
(2008).
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK – DO NOT USE THIS FAN WITH ANY SOLID STATE
SPEED CONTROL DEVICES.
