9
Switch action
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the “OFF” position when
released.
To start the tool, simply pull the switch trigger. Tool speed is
increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Electric brake
This tool is equipped with an electric brake. If the tool consis-
tently fails to quickly stop after switch trigger release, have
tool serviced at a Makita service center.
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Slide the reversing switch to the A side (appear “F”
marking) for clockwise rotation or to the B side (appear “R”
marking) for counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Usethereversingswitchonlyafterthetoolcomestoa
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Installing or removing driver bit or socket bit
Use only the driver bit or socket bit shown in the figure. Do
not use any other driver bit or socket bit.
1. Switch trigger
1
002813
1. Reversing switch
1
A
B
002820
12 mm
(15/32”)
9mm
(3/8”)
001266
