Makita PW5001C Manual

A SERVICE OF

next previous

10

Installing or removing the front grip

CAUTION:

• Make sure that the front grip is installed securely before

operation.

• The front grip and the side grip cannot be installed at the

same time.

Remove two screws and then the head cover.(The front grip

cannot be installed during the installation of head cover on

the tool.)

Install the front grip on the tool so that its stopper fits to the

gear housing and tighten the two screws as shown in the fig-

ure. (The front grip and the side grip cannot be installed at

the same time.)

Installing or removing abrasive disc

(Optional accessory)

Remove all dirt or foreign matter from the pad.

Screw the pad onto the spindle with pressing the shaft lock.

Attach the disc to the pad so carefully that the edges of disc

and pad overlap each other without protruding.

To remove the abrasive disc, pull off its edge from the pad.

1. Head cover

2. Screw

1

2

005586

1. Gear housing

2. Stopper

3. Front grip

4. Flat washer

5. Hex socket head bolt

1

2

3

4

5

005587

1. Abrasive disc

2. Pad

3. Spindle

1

2

3

006100

006101