Assembly
dk
Adjusting
ADJUSTING HOLD DOWN
The hold down should be adjusted
so
it contacts the
top surface
of
the work being cut by loosening
adjusting knob and moving hold down rod up
or
down.
Tighten adjusting knob after adjustment has been
made.
Hold Down Rod
Lock
Knob
ADJUSTING DUST BLOWER
The dust blower may be moved to direct air
to
the most
effective point on the cutting line by loosening screw, adjust
dust blower accordingly and tighten screw.
Blade support
&
Guard
Set
Screw
Blade support
&
Guard
Sawdust Blower
Set
Screw
Sawdust Blower
ALIGNING THE BEVEL INDICATOR
1.
Loosening the hold down adjusting knob and moving hold
down rod up. Then tighten adjusting knob.
2.
Loosen the table lock knob and move the table until it is
approximately perpendicular, or at a right angle
to
the
blade.
3.
Place a small square on the table next to the
blade
to
check
if
the table is
90
degrees
to
the blade.
If
adjustment is needed, raise or lower the table
until table is approximately
90
degrees
to
the
blade and securely tighten the table lock knob.
4.
Loosen the screw holding the degree scale
pointer, move pointer
to
the
0
degree mark and
securely tighten screw. Remember, the degree
scale is a convenient guide but should not be
relied upon for precision. Make practice cuts
on scrap wood
to
determine
if
your angle
setting are correct.
DWrm
5.
Remove the hold down rod to desired position.
9
