115
General
Language
Default settings are underlined.
Set the language for display on the menu screen.
Setting details
English / Français / Español
“Language” can also be set by the following procedure. However, the menu screen is not displayed.
Following the display content to make the setting.
1. Press and hold the main unit’s PRESET CH – and STATUS for at least 3 seconds.
“V.Format:<NTSC>” appears on the display.
2. Press the main unit’s DISPLAY and set “Lang.:<ENGLISH >”.
3. Use the main unit’s PRESET CH – or PRESET CH + and set the language.
4. Press the main unit’s STATUS to complete the setting.
Auto Standby
Default settings are underlined.
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, “Auto Standby” is
displayed on the display of this unit and the menu screen.
Setting details
60 min : The unit goes into standby after 60 minutes.
30 min : The unit goes into standby after 30 minutes.
O : The unit does not go into standby automatically.
Front Display
Default settings are underlined.
Makes settings related to the display on this unit.
Setting items Setting details
Display
On : Display is always on.
Auto O : Display is o except when showing the status display.
O : Display is always o.
Buttons on the main unit can be used for operations.
Each time DISPLAY is pressed, the setting is changed as shown
below.
On Auto Off
Off
NOTE
When “Display” is set to “O”, the display turns o and appears as if
there is no electricity.
