A SERVICE OF

logo

Owner’s Manual 77-120 ESP
www.midlandradio.com Page 2 of 13
Table of Contents
I. Introduction
II.
How to install your Midland mobile CB
III. Check the requirements for your vehicle before you begin installation
IV.
Installation and operating accessories furnished with your Midland CB
V.
Where to locate your CB transceiver
VI. Mechanical Mounting
VII. Power wiring (negative ground only)
VIII.
Mounting the main unit
IX.
Installation of microphone hanger
X. Antenna
a. How to select, position install and tune the right one for you?
b. Where you locate your antenna does make a difference.
c. Antenna Installation
d. Tuning your antenna
XI. Function & Location of Controls
a. Front Panel Controls
b. Microphone Connector
c. ON/OFF Volume
d. MIC Gain
e. Squelch Control
f. RF Gain Control
g. Rotary Channel Selector
h. Channel Display
i. Frequency Display
j. TX Indicator
k. WX Indicator
l. ESP Indicator
m. S/RF Display
n. CB/WX
o. CH.9 Switch
p. ESP
q. FRQ
XII. Back Panel
a. Antenna Connector
b. S-Meter Jack
c. EXT Speaker Jack
XIII. How to operate your Transceiver for CB Use.
XIV. How to operate your transceiver for weather receive
XV. How ESP2 works
XVI. Technical Data
XVII. Warranty