Replacing the light bulb
Disconnect the dryer from the
electrical supply.
^
Open the door.
The hinged cover for the lighting is over
the port-hole.
^ Gently insert an ordinary tool* under
the side of the cover.
* such as a wide slot-type screwdriver
^
Open the cover by pressing lightly
while rotating your wrist.
The cover opens downwards.
The heat-resistant bulb should be
obtained only from Miele customer ser
-
vice.
The bulb should be of the same type
and maximum wattage indicated on
the data plate and the lighting cover.
^
Replace the bulb.
^
Fold the cover upwards and press it
on the right and left until you hear it
latch.
,
Ensure that the cover is properly
seated. If moisture gets inside it may
cause a short-circuit.
Trouble shooting
34
