20
20
ANT-A
IR EMITTER HOME THEATER
S-VIDEO
COMPONENT
L
(MONO)
R
ANT -B
CABLE
LOOP-OUT
INPUT INPUT OUTPUT
FIXED/
VARIABLE
2
1
VHF/UHF
(75 OHMS)
V
I
D
E
O
A
U
D
I
O
TUNER/
MONITOR
L
R
Y
Cb
DVD
(YCrCb)
AUDIO
Cr
TV back panel
A/V Receiver
1
D IGI TA L
SU R R O U N D
S
CH
Other A/V Device
D IGI TA L
SU R R O U N D
S
CH
Figure 1. Connecting the System 4 Home Theater IR
Control.
See page 53 for details on using the
TV’s IR emitter to control a Mitsubishi
A/V receiver.
Part II: Installation
Connecting the System 4 Home Theater IR Control
Connect the IR emitter to IR EMITTER
HOME THEATER on the TV back panel.
Place the IR emitter cable under or
along the side of the A/V device. Place
the IR lens directly in front of the A/V
device’s infrared signal receiver. Infra-
red signal receivers are usually behind
the front translucent panel of the device.
Place unused transmitters in an out-of-
the-way location.
For permanent installation of the IR
emitter cable, use the included adhesive
tape to secure the bottom of the emitter
to the anchoring object of your choice.
Connecting the System 4 Home Theater IR Control
Models VS-60719, VS-70709. (Figure 1)
