Nady Systems ENCOREDUETHTLTPR Manual

next previous

5. Connecting the Audio Output

TheEncoreDUETreceiverprovidesbothaxedmiclevelBALANCED AUDIO OUTPUT

XLR (14)foreachchannelandanadjustablelinelevelA + B UNBALANCED AUDIO

OUTPUT 1/4" JACK (13) whichprovidesamixed(summed)ChAplusChBoutput

signal.ThemixedlevelfromtheA + B UNBALANCED OUTPUT is controlled by the rear

panel VOLUME CONTROLS (6) for each channel.

(Note: As when making any connection, make sure the ampliﬁer or mixing board

volume is at the minimum level before plugging in the receiver to avoid possible

sound system damage. Also make sure that the phantom power on the input of the

mixer is turned OFF before making connection to the receiver.)

a. Instrument Connection(usingtheWGTinstrumenttransmitter)

 Insertanaudiocordwitha1/4"monophoneplugintheA + B

UNBALANCED OUTPUT JACK (13) on the rear panel of the receiver. Plug the

otherendofthecordintoanamplier,effects,ormixingboard.Adjustthe

appropriate VOLUME CONTROL (6) for the channel being used on the Encore

DUETreceiverclockwisetoabout3/4rotation,untilthemixedvolumelevelis

comfortable for your application. This setting is roughly equivalent to a direct

instrumentcordconnection.Turningthevolumeuptomaximumwillprovide

4dB gain over a cord. (Note: Since this a mixed output of Ch A & Ch B, both

channels with be processed simultaneously by the ampliﬁer and/or effects

connected to, which may not be appropriate for your application.

b. Microphone Connection(usingtheWLTtransmitterwitheitheraheadset

orlavaliermicrophoneortheWHThandheldmicrophonetransmitter)

For microphone use, either the BALANCED MIC AUDIO OUTPUT XLRs (14) or the

1/4" line level A + B UNBALANCED OUTPUT (13)canbeused.TheXLRoutput

issetatanon-adjustablemicrophonelevel,similartohardwiredmiclevels.

PluganXLRconnectorintoeitherorbothoftheXLR OUTPUT JACKS on the

rearoftheunitandplugtheotherendintoyouramplierormixingboard.

(Note: Make sure the phantom power on your mixing board is turned off

and the volume is turned down when making connections.)

Foryourconvenience,theXLRoutputlevelsarepresetatthefactoryand

arenotadjustablewiththereceivervolumecontrols.Tousethe1/4" A + B

UNBALANCED OUTPUT JACK (13), follow the instructions for the Instrument

Connection(above),exceptstartwiththereceivervolumeat1/2MAX

andadjustthevolumecontrolforeachchanneluntilthemixedChAand

Ch B volume level is optimal. If the volume controls are set too high, you

mayoverloadyourmixeroramp.