MULTI CONTROL
12.5.10 C67 WIND SPE
To set a wind speed al
true wind speed is higher than the set level. To switch of the
alarm, set C67 to 00. To silen a .
The alarm level is set from 1 to 50 m/s.
To set the alarm level,
required. To store the s
Note! The Alarm level is
If the set alarm level is ach t ed, the wind speed must drop
below 50% of the set ala
12.6 C70, calibra
When calibration code C70 is selected, the LCD arrow
functions will be display
12.6.1 C70 (RET
To return to the normal mode
12.6.2 C71 (OFF
(On) = Sound when pus
12.6.3 C72 (d0 S
Damping of speed and course over ground (SOG/COG), affecting the complete
Nexus Network and NMEA output.
d0 = no damping. d1 = 2 sec, d2 = 5 sec, d3 = 10 sec, d4 = 20 sec, d5 = 40 sec, d6 =
1.20 min, d7 = 2.40 min, d8 = 5 min and d9 = 10 min.
12.6.4 C73 (OFF BSP)
(OFF) = NX2 log transducer. (On) = NMEA log transducer.
If you want to use a NMEA transducer (connected to the NMEA input, you have to set
C73 to On. The Server will then transmit this information on the Nexus Network to all
connected instruments.
After you have changed this setting, you have to restart the system
12.6.5 C74 (OFF DEP)
(OFF) = NX2 depth transducer. (On) = NMEA depth transducer.
If you want to use a NMEA transducer (connected to the NMEA input, you have to
set C74 to On. The Server will then transmit this information on the Nexus Network
to all connected instruments.
After you have changed this setting, you have to restart the system
ED ALARM (WSA)
arm level. The buzzer will sound when the
ce an al rm, press any key
press SET. To select level, press PAGE, PLUS or MINUS as
elected value, press SET.
always set in m/s regardless of unit used for displaying!
re ed and he alarm Is silenc
vel to be activated again.
rm le
tion of Network and NMEA
s for all
ed
)
, press SET.
KEY)
h buttons are pressed. (OFF) = no sound.
EA)
47
