11.2 Configure the settings relating to JPEG images
[JPEG/H.264] (or [JPEG/MPEG-4])
Click the [JPEG/H.264] tab (or [JPEG/MPEG-4] tab) on the “Image/Audio” page. (®page 47, page 49)
JPEG
Configure the settings such as “Refresh interval (JPEG)*”, “Image capture size” and “Image quality” on this
section. Refer to page 82 and page 88 for further information about the settings relating to H.264 (or
MPEG-4) images.
“Live” page (Initial display)
Configure the settings relating to the JPEG images displayed on the “Live” page.
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image from the following.
:
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*
• Default: 5fps
:
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps/ 10fps/ 12fps*/ 15fps*/ 30fps*
• Default: 10fps
Note
• When “On” is selected for “H.264 transmission” (or “MPEG-4 transmission”), the refresh interval may
be longer than the set value when any value with an asterisk (*) on the right is selected.
• Depending on factors such as the network environment, the resolution, the image quality, or the number
of computers concurrently accessing the camera, the transmission interval may be longer than the set
value.
• If images are not delivered in the specified transmission interval, you can make the images be delivered
closer to the specified time by lowering the resolution or image quality.
[Image capture size]
Select the image capture size to display the JPEG image on the “Live” page for the first time.
When “4:3” is selected for “Aspect ratio”
:
QVGA/ VGA/ 1280x960
80 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
