A SERVICE OF

logo

14
EN
5.
5.The decoded data appears after confirma-
tion.You can go back to change the data.
Select the corresponding input field using
or
. Change the data with
.
6.
6.When all inputs are correct, press
.The programming information is
stored in a TIMER block.
7.
7.Insert a cassette with an intact security tab
(unprotected).
Helpful Hints
STATUS/EXIT
0..9
CLEAR
FWD 1- B
Switching on 'VPS/PDC' in the 'START' input
field
Select 'VPS/PDC' using .
Press '1' to switch off 'VPS/PDC' or press '2' to
switch on 'VPS/PDC'.
CLEAR
FWD 1- B
The TV-Video Combi will not operate
* If you want to cancel the programmed record-
ing, press longer than 3 sec-
onds.
Cassette is ejected during recording
* The end of the tape was reached during
recording.
Error message:
* If you forgot to insert a cassette,'INSERT
CASSETTE FOR TIMER RECORDING' will
appear.
Error message:‘FULL’
* If this error message appears after pressing
, then all TIMER blocks are already pro-
grammed. No more recordings can be pro-
grammed. If you want to clear a programmed
recording (TIMER block), select the programme
number on TIMER LIST menu and press .
Cassette was ejected as soon as inserted.
* If a cassette with the security tab removed
was inserted, 'PROTECTED CASSETTE
TIMER CANNOT RECORD' will appear.
Undo the erase protection (chapter 'Manual
Recording', section 'Preventing accidental eras-
ing') or insert another cassette.
CLEAR
SV/V
+
STANDBY/ON
yy
Prog No changes to ' - - '
* The entered PlusCode number is incorrect.
Correct your input or end with
.
The following message appears on the
screen:'ERROR'
* The entered PlusCode number is incorrect.
Correct your inputs or end with .
* Check the time/date (see chapter 'Installing
your TV-Video Combi', section 'Setting the
clock').
* A daily recording was entered for the wrong
day. Daily programming can only be used for
recordings to be made from Monday to Friday.
The following message appears on the
screen:’TIMER NOT COMPLETED’
* The channel is wrong.
STATUS/EXIT
STATUS/EXIT
T6400EZ-UK(EN).qx3 03.2.20 2:57 PM Page 14