utoLock allows the viewer to block out any channels. A channel blocked by the AutoLock control cannot be viewed
until a correct access code is used to unlock the channel for viewing.
Follow these steps for Digital Mode Follow these steps for Analog mode
Press MENU button on
the remote control to
display the onscreen menu.
Press CURSOR A or
V to scroll through the
onscreen menu until
you see DTV Setup
highlighted. Press
CURSOR > to display
DTV Setup features.
Press CURSOR A or
V to scroll through the
DTV Setup features until
Ch. Install is highlighted.
Press CURSOR >
followed by CURSOR
A or V until
you see AutoLock
highlighted.
Press CURSOR > to
enter the AutoLock
mode.
"Password " will
appear.
Press CURSOR >
followed by the
NUMERIC buttons on the
remote control to enter
the access code. 0711
is the default. The first
time you enter the code,
Incorrect will appear on
the screen. Enter the same
code again. Correct will
be displayed. Now can
proceed to block channels.
Digital Mode
IMain I
<_Picture
<>Sound
o Features
<>install
IChchln_tn_llEdit _ I
_ Password
o Fact CH Reset ncorrect
i
_ Password
o Fact CH Reset Correct I
J
I I
Analog Mode
IMain I
o Picture Timer
o Sound Rotation
kFeatures _ IAut°L°ck
o Inst_ll Close Cap
Active Control
IFeatures ]
0 Time Access Code
o Rotation
o Active Control Incorrect
Features _ ]
0 Time New Code
o Rotation
Active Control
Aut0L0ck
_hannn_ O_
o Setup Code
o ClearAll
o BlockAll
MovieRa_ng
TV Rating
[
MENU =
A V<>=
NUPIERIC =
FORMATCLOCKSLEEP GUIDE
0000
©®©@
@
©©®
-®®®
©®®
G®®
!
-- AID
toggles between
digital and analog
mode
When you are in Digital Hode you can only
AutoLock Digital Channels.
When you are in Analog Mode you can
only AutoLock Analog Channels.
Press MENU button on
the remote control to
display the onscreen menu.
Press CURSOR A or
V to scroll through the
onscreen menu until you
see Features highlighted.
Press CURSOR > to
display the Features
menu.
Press CURSOR A or V
repeatedly until you
see AutoLock highlighted.
Press CURSOR > to
enter the AutoLock
mode.
"Access Code " will
appear.
Using the NUMERIC
buttons on the remote
control enter the access
code. 0711 is the default.
The first time you enter
the code, Incorrect will
appear on the screen.
Enter the same code again.
You will be prompted to
enter a new code.
Use the NUMERIC
buttons on the remote
control enter the access
code of your choice.
Enter the same code a
second time to confirm
it. Once the new code is
confirmed, the AutoLock
menu will appear. You can
now access the functions
available in the menu.
Note : Remember this new code
which you have set. You can use
this code to access AutoLock
features in both Digital and Analog
mode. Ifyou forget the new code
you have set, key 0711 to access
AutoLock features.
21
