Connect the blue wire to the terminal marked N or coloured black. •
Connect the brown wire to the terminal marked L or coloured red.•
Do not connect either wire to the earth terminal in the plug, •
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
a Remove fuse cover and fuse.
b Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI
approved type.
c Ret the fuse cover.
Ifthettedplugisnotsuitableforyoursocketoutlets,itshouldbe
cutoffandanappropriateplugttedinitsplace.
Warning
Never remove the casing of this apparatus. •
Never lubricate any part of this apparatus. •
Never place this apparatus on other electrical equipment. •
Keepthisapparatusawayfromdirectsunlight,nakedamesorheat. •
Never look into the laser beam inside this apparatus. •
Ensure that you always have easy access to the power cord, plug or •
adaptor to disconnect this apparatus from the power.
Where the MAINS plug or an appliance coupler is used as the disconnect •
device, the disconnect device shall remain readily operable.
Caution
Use of controls or adjustments or performance of procedures other •
than herein may result in hazardous radiation exposure or other
unsafe operation.
