12
English
Firmware upgrade
Occasionally, Philips releases new software (“firmware”) for your unit.
1 Connect the power adapter to 4.5V DC on the unit and to the power outlet
(see “Power adapter”).
2 Keep MODE pressed for 3 seconds.
➜ The type of your unit and the current version
of the firmware are displayed. Upgrade? is
displayed.
3 Press 9.
4 Visit the Philips Audio homepage www.audio.philips.com. Check if there is a
firmware file for your unit and if the firmware version is higher than the current
version of your unit. Download the file and burn it on an 8 cm CD-ROM.
5 Insert the CD-ROM into the unit and keep MODE pressed for 3 seconds.
➜ Upgrade? is displayed.
6 Press 2;:
➜ Upgrading is displayed and upgrading starts.This may take some minutes.
After upgrading is finished, Upgrade complete is scrolled.
➜ Wrong upgrade file is scrolled:Your unit already has the latest firmware
or the downloaded file does not correspond to your unit.
➜ Upgrade file defect is scrolled:The upgrade file has been damaged
during the download or when burning the CD-ROM. Download the file
again, burn a new CD-ROM and try again.
➜ No upgrade file is scrolled: No upgrade file was found on the inserted
CD-ROM.
Note: If upgrading is interrupted accidentally, repeat steps 5 and 6 until upgrading
is completed successfully.
General information
