26
English
3139 115 20912
To reset tape counter number
● When in stop mode, pressÇ.
➜ “TP1 000” or “TP2 000” will be displayed.
Notes:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (VCD,
TUNER or AUX, for example).
– The tape counter will automatically set to zero
after detecting end of tape.
General Information on
Recording
● If you do not intend to record via the
microphone, unplug the microphone to avoid
accidental mixing with other recording source.
● For recording, use only tape of IEC type I
(normal tape).
● The recording level is set automatically, regardless
of the position of the Volume, VAC, DSC and so
forth.
● The tape is secured at both ends with leader
tape. At the beginning and end
of the tape, nothing will be
recorded for six to seven
seconds.
● To prevent accidental recording,
break out the tab on the left
shoulder of the tape side you
want to protect.
● If “CHECK TAPE” is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening.
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only on tape deck 2.
Preparation for Recording
1 Press TAPE (TAPE 1•2) to select TAPE 2.
2 Load a recordable tape into tape deck 2 with full
spool to the left.
3 Prepare the source to be recorded.
VCD – load the disc(s).
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 1 with the full spool to the left.
AUX – connect external equipment.
When recording is in progress
➜ starts flashing.
● It is not possible to listen to another sources
except when dubbing tapes.
● It is not possible to activate the timer function.
One Touch Recording/Recording
the mixed sound
1 Press VCD, TUNER or AUX to select the
source.
● You can connect a microphone to record the
mixed sound in tape deck 2 (refer to “Karaoke -
Microphone Mixing”).
2 Start playback of the selected source.
3 Press REC to start recording.
To stop recording
● Press Ç on the system.
Note:
– One Touch Recording is not possible in TAPE
mode, "SELECT SOURCE" will be displayed.
CD/VCD/MP3-CD Synchro
Recording
1 Press VCD to select the disc.
● Press í or ë to select the desired track to
start recording.
● You can programme the tracks in the order you
want them to be recorded (refer to “CD/VCD/
MP3-CD Operation - Programming the disc
tracks”).
2 Press REC to start recording.
➜ The disc will start playback automatically.
To select another track during recording
1 Press PAUSEÉÅ to interrupt recording.
2 Pressí or ë to select the desired track.
3 Press PLAYÉÅ to resume recording.
Tape Operation/Recording
pg 001-032/V720/21-Eng 6/5/01, 6:41 PM26
