6 Hooking Up the TV/VCR
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
Jack on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal or an anten-
na to the ANT(enna) Jack.
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
1
Hook up your TV/VCR using one of the connections shown.
A.
B.
Hooking Up Your TV/VCR With an
Indoor Antenna
To install a rod antenna (not supplied), push
the stem of the antenna into the antenna hole
on the top of the TV/VCR. Connect the
antenna wire to the ANT(enna) Jack on the
back of the TV/VCR as shown. Extend the
antenna and adjust its length, direction, and
angle for the clearest picture.
C.
Connect the Cable signal to the IN
Jack on the Cable Box.
