11
Customer Service Hours of Operation: Monday-Friday, 9am-5:30pm est polkcs@polkaudio.com
How To Set Up A Remote Control
For Your SurroundBar
SmartBar™ Programming Note:
For your SurroundBar to respond to your remote
control, you MUST FIRST program the bar to
respond to your television’s original IR (Infra-Red)
remote. An RF (Radio Frequency) remote will
not work. Other remotes (cable, satellite) will
work only after you have programmed the bar
to respond to the TV’s IR remote.
Programming Instructions:
Your SurroundBar is currently programmed to
respond to the remote control that is included with
the product. However, we strongly recommend
programming the SurroundBar to also respond
to your existing remote control using the steps
illustrated below. This will enable you to oper-
ate all of your components using a single remote
control. While programming the SurroundBar,
ignore anything that may be displayed on the
TV screen.
Example:
To teach your bar the “Volume Up”
command of your remote control:
2
3
4
LED
Press and hold “LEARN” for 2 seconds, or until LED
blinks blue, then release the “LEARN” button.
1
The SurroundBar is turned on and the LED is solid green.
And you have sound coming from the bar.
Hold TV remote 6" - 1' from SurroundBar.
Press and release Volume Up “
+ ”
LED turns solid blue.
Solid blue
LED
Blinks blue
LEARN LED blinks with
each button press
LED
Volume Up button
LED blinks blue
LED
LED blinks blue
Tap “Volume Up” button on your TV’s remote control
4 - 8 times, once per second. Tap, do not hold.
6
When the LEARN LED and the button (command)
both blink blue, the command has been learned.
6" - 1'
