Attaching the Front Forks
Insert the spacer sleeves on
the top and bottom of the frame.
Slide the fork into position
and insert the steering bolt.
The bolt must go through the
washer and spacer sleeve and
between the steering bearings
properly adjust and tighten the
clamps and retainers that affi x
the forks can cause you to lose
Install washer and nut onto
steering bolt. Tighten until snug,
then back off slightly to allow
the steering to rotate freely with
Your electric chopper may not have a fully charged battery. Th
nitial charge time: 12 hours •
Run time: up to 40 minutes
• Recharge time: up to 8 hours •
250 charge/discharge cycles
depending on the level of depletion.
charger works with the power
switch in either the on or off
lug the charger plug into a
before cleaning with liquid.
not look like the one illustrated,
your unit has been supplied
with an alternative charger. The
specifi cations and charging
procedure would not change.
window with one LED or two
LEDs to indicate the charge
status. Refer to the illustration
on the charger unit for the
actual “charging” and “charged”
status indications for your
hargers have built-in over-
charge protection to prevent
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
