29
Editing the Tones (TONE)
Parameter List (MODELING TONE)
Group Parameter Value Description
TONE
SWITCH OFF, ON Turns the tone on/o. Tones turned “OFF” will not sound (i.e., they are muted).
TONE CATEGORY
If GUITAR<->BASS is set to “GUITAR” (p.9)
E.GTR,
AC,
E.BASS,
SYNTH
Selects the category (group) of tones.
If GUITAR<->BASS is set to “BASS” (p.9)
E.BASS,
SYNTH,
E.GTR
Selects the category (group) of tones.
TONE NUMBER 001–
Selects the tone. For an explanation, refer to the following table (TONE CATEGORY:
E.GTR–SYNTH).
LEVEL 0–100 Adjusts the volume of the tone.
STRING LEVEL1–6 0–100
Adjusts the volume of each string.
For the PCM1, PCM2, and MODELING tones, you can specify a value of “0” for each
string that you don’t want to be sounded for that tone; this allows you to create “split”
setups.
PITCH
PITCH SHIFT -24–+24 Adjusts the pitch of the tone (in semitone steps, +/-2 octaves).
PITCH FINE -50–+50 Adjusts the pitch of the tone (in one cent steps; equivalent to 1/100 semitone).
12STR
12STR SW OFF/ON
Turn this on if you want to produce the sound of a 12-string guitar. The sound of a
conventional 6-string guitar will be transformed to the sound of a 12-string guitar
with its supplementary strings.
DIRECT LEVEL 0–100 Species the volume of the main strings.
SHIFT1–6 -24–+24
Adjusts the pitch dierence of each
supplementary string relative to
the corresponding main string, in
semitone steps.
* On a conventional 12-string guitar,
supplementary strings 1 and 2 are tuned
to the same pitch (SHIFT = 0) as the corre-
sponding main string, and supplementary
strings 3–6 are tuned one octave higher
(SHIFT = +12) than the corresponding
main string. Slightly raising each string’s
FINE setting will produce a more realistic
12-string guitar tone.
FINE1–6 -50–+50
Adjusts the pitch of each
supplementary string in cents
(1/100 semitone steps).
* 12STR cannot be used with any of the following settings (the parameters will not be shown).
• MODELING TONE parameters
TONE CATEGORY=E.BASS (if set to GUITAR input) or E.GTR (if set to BASS input)
PITCH SHIFT≠0
PITCH FINE≠0
• MASTER parameters
ALTERNATE TUNING “SWITCH” =ON
