1: Power switch - As you may have guessed, this is what you use to turn the
S63 on and off. The built-in protection relay circuitry (which mutes the outputs for
approximately five seconds after powering on) prevents power-on “thumping,”
which can potentially damage connected speakers.
2: Fuse holder - Insert a 6 amp fuse here for 120 volt operation. Insert a 3.5
amp fuse here for 220 volt operation.
3: Effect Returns - These unbalanced inputs allow you to route signal from
external devices such as effects processors to the Effects Return section of the
S63. Because the S63 is a monophonic system, stereo signals input to the pair
of Effects returns 1-2 are automatically mixed to mono. See the “Using the
Effects Sends and Returns” section in this manual for more information.
4: Effects Sends - These unbalanced outputs allow you to route signal from
each of the two discrete Effects Sends to external devices such as effects
processors. Effects Send 1 is pre-fader and pre-EQ, while Effects Send 2 is
post-fader and post-EQ. See the “Using the Effects Sends and Returns” section
in this manual for more information.
14
Guided Tour - S63 Rear Panel
DO NOT OPEN. NO USER
INSIDE. REFER SERVIC-
PERSONNEL. TO PREVENT
IN R.O.K.
