Adjustment tips for the operating menu
23
Adjusting the bass roll-off frequency – “LOWCUT”
To reduce unwanted low-frequency noise such as wind and handling noise, you can activate a
low-cut filter. The low-cut frequency is 120
Hz.
If you do not want to reduce low-frequency signal portions, select the setting “FLAT”.
Selecting the standard display – “VIEW”
Via the “VIEW” menu, you can select one of the following standard displays:
The selected standard display is shown
• after switch-on,
• after the menu settings have been displayed for 10 seconds in display mode.
Loading the factory-preset default settings – “RESET”
Via the “RESET” menu, you can load the factory-preset default settings. After the reset, the
standard display is shown on the LC display panel.
Transmission
frequency “FREQ”
Channel
“CHAN”
Name
“NAME”
Function Setting
Low-cut frequency “FLAT”
Microphone sensitivity “0 dB”
Name “SK5212”
Standard display Transmission frequency
Autolock function deactivated
Channel “FIX 01”
Output power “PWR.HI”
Frequencies in the frequency bank “VAR” are reset.
RF
MHz
