A SERVICE OF

logo

Important Safety Instructions:
Battery Installation:
What’s Included:
Transmitter Controls:
Headset Controls:
1) Headset Receiver
2) Transmitter
3) RCA to Phono Plug Adapter
4) Stereo Mini-Plug Adapter
5) Hi-Fi Stereo Adapter
Transmitter:
1) Audio Input Jack
2)AC/DCJack
3) Telescopic Antenna
4) LED Power Indicator
5)ON/OFFButton
6)BatteryCompartment
Headset Receiver:
1)ONButton
2)OFFButton
3)VolumeControlDial
4) LED Power Indicator
5)BatteryCompartment
6)BatteryCompartmentLatch
•Toavoidinjurytoearsandstereoplayer,lowervolumebeforepluggingheadphonesintodevice.
•Itisnotadvisabletolistentoheadphoneswhilecycling,drivingavehicleoroperatingmachinery.
•Avoidlisteningforprolongedperiodsathighvolumewhichmaydamagehearing.
Transmitter:
1.Openupthebatterycompartmentonthetransmitterandinsertone‘9V’battery.
2.Replacethecovertothetransmitter’sbatterycompartmentbyslidingitbackon.
Headphone:
1.Openthebatterycompartmentbyslidingthelatchdownward.
2.Putintwo'AAA'batteries.Makesuretheyareplacedinthecompartmentwiththepolarity
inthecorrectposition(+/-).
3.Closethecompartmentbyslidingthecoverbackon&closingthelatch.
Using the Optional 12V Power Adapter:
TheTransmittercanalsobepoweredbyanoptional300mA12VPowerAdapter.
AC/DCAdaptersaresold separately and are available at most home electronics retailers
or department stores. To use the Power Adapter:
1.ConnectthePowerAdaptertothetransmitter.
2.PlugthePowerAdapterintoanearbyelectricaloutlet.
NOTE: Make sure the Power Adapter is the correct voltage and polarity as indicated on the
transmitter. Failure to do so may cause damage to the transmitter.
If Something Doesn’t Sound Right:
If you experience static, distortion, or signal loss while listening to the Headphones:
1.RefertotheQUICK-STARTGUIDEandverifythatallofyourconnectionsarecorrect.
2.Makesurethatallconnectionsaresecure.
3.MakesuretheTransmitterisconnectedtothe“Audio-Out”jacksofthesourcedevice.
4.ReplacethebatteriesineithertheHeadsetortheTransmitter.
5.Makesurethatthesourceaudiodeviceisturnedonandsettoareasonablevolume.
6.Ensurethatyouarewithinapproximately100feetoftheTransmitter.
Plugging in and Turning On:
Please refer to the QUICK-START GUIDE included with this product for detailed instructions
on connecting the Transmitter to most commonly used audio devices.
1.ConnecttheTransmittertothe“Audio-Out”jacksofyouraudiodeviceusingthesupplied
cables and adapters. (NOTE: When connecting the Transmitter to a Television, the RCA
“Audio-Out” jacks are located on the back of your TV Set, not the front).
2.Makesurethatyouraudiodeviceisturnedonandsettoareasonablelisteningvolume.
3.FullyextendtheTransmitter’sTelescopicAntenna.
4.TurntheTransmitteronbypressingthe“OnButton”locatedonfrontoftheTransmitter.
5.TurntheHeadsetonbypressingthe“OnButton”locatedonthesideoftheHeadset.
6.AdjustthelisteningvolumetoacomfortablelevelusingtheHeadset’sVolumeControlDial.