72
HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press POWER on the
Display or B on the remote control unit to turn the System on.
All setting items (except TV channel) return to the factory presets.
A
• Running the factory preset operation also clears the password.
You can run the Auto Installation again by using the following steps.
1 Turn on the power of the Display and the AVC System.
2 Press MENU. (Make sure the menu screen displays.)
3 Press b to select “Setup”.
4 Press ENTER.
A
• If the password setting screen displays, you need to enter your password.
• If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.
5 Press a/b to select “Auto Installation”.
6 Press ENTER.
“Auto Installation completed.” displays. After that, the screen changes to the TV mode.
A
• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar
place.
The password is .
