5
Attaching the stand unit
•
Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
•
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
•
After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
1 Confirm that there are 11 screws (four long
screws, five middle screws and two short
screws) supplied with the stand unit.
2 Attach the supporting post for the stand unit
onto the base using the long screws with a
screwdriver as shown.
Long screws
Supporting
post
Stand base
3 Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion
4 Insert and tighten middle screws into the holes
on the rear of the TV.
Middle screws
5 Attaching the stand cover.
1 Insert the stand cover.
2 Insert and tighten the short screws into the
holes of the stand cover.
Short screws
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.
• The TV can be rotated up to 20 degrees to the right and
left.
Preparation
