5
Steps 6, 7 & 8 apply to Satellite Radio Emulation Mode
ONLY
6. Connect the 8-Pin auxiliary input cable to the second port (closest to the
dipswitches) on the Media GateWay if an additional auxiliary input is desired.
7. If connecting the Satellite Radio tuner (SCC1 sold separartely), make the following
connections before connecting the PXAMG to the vehicle. Plug the black end
of the 3 foot ISSR11 (8-Pin mini-din to 8-Pin mini-din; sold seperately) into the
second port (closest to the dipswitches) on the Media GateWay. If you are
installing the Satellite Radio Tuner with the HDRT, connect the ISSR11 cable to
the port farthest from the dipswitches. Connect the gray end of this cable into the
Satellite Radio tuner.
8. If connecting the ISBT21 (sold separartely), make the folllowing connections before
connecting the PXAMG to the vehichle. Plug the 3 foot ISBT21 Cable (8-Pin
mini-din to 8-Pin mini-din) cable into the rst port (farthest from the dipswitches) on
the Media GateWay. Connect the other end of this cable into the ISBT21. Connect
the microphone cable into the 3.5 mm connection on the ISBT21.
9. Plug in the male connectors on the PGHFD1 harness into the 24-pin port and 16-
pin port on the back of the radio. Next, connect the factory 24-pin and 16-pin
harness (if present) into the female connectors on the PGHFD1 harness. Be sure
to make a rm connection but do not force it. If you are using the PGHFD1A
harness, the 4 pin plug on this harness will connect to the 4-Pin plug on the
PGHFD1 harness. The 12 pin plug on this harness will replace the current 12-
pin harness connected to the LCD screen mounted above the radio. Disconnect
the factory 12-Pin harness and do not reconnect. Plug the 12-Pin connector of
the PGHFD1A harness into the LCD display. Again make a rm connection, but do
not force. Plug the black micro-t 24-pin connector on the PGHFD1 harness into
the PXAMG Media GateWay box.
10. To complete the installation secure the Media GateWay (PXAMG), HD Radio
tuner (HDRT) or the SCC1 into the cavity in the dash behind the radio. Be sure
that the cables and interface modules are not near moving parts or sharp metal
edges as they may damage the cables. To prevent rattling noises inside the dash,
use zip ties, tape, or other fasteners to mount the interfaces securely.
11. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the Media GateWay
and HD Radio tuner before reinstalling the factory dash panels.
12. Note: The rst time you access the GateWay, your radio may display “DEV INIT”
while the device is initializing. After initially connecting the GateWay, please wait
one minute then cycle the ignition off and on. Then access SAT mode again to
begin normal GateWay operation.
