6
Installation Instructions Sub-Frame Hitch
REMOVAL
NOTE: After removing components, reinstall the clevis
pins and clips to prevent loss.
1. Disconnect the lift rod from the attachment and lift
lever (C, Figure 10).
2. Remove the clevis pin and clip from the lift lever (C)
and remove the lift lever.
3. Remove the front hitch rods (A) and (B). Remove the
hitch and hook (F).
4. Remove the lock plate (D, E) or switch the lift link
from dozer to mowing position (see page 7).
NORMAL INSTALLATION
1. Insert the hook (F, Figure 10) into the back of the
hitch. Mount the rear of the hitch on the lift cross-
shaft.
2. Secure the front of the hitch to the J-hooks using the
hitch rods (A) and (B) (Figure 7).
3. Install the downward pressure lock plate or switch the
lift link (see page 7).
4. Install the lift lever (C).
5. Install the lift rod and attachment (Figure 8).
Figure 10. Normal Installation & Removal
A
C
D
E
F
A. Hitch Rod
B. Hitch Rod
C. Lift Lever
D. Pressure Lock Plate
(Manual)
E. Pressure Lock Plate
(Hydraulic)
F. Hook
OBSOLETE
B
