17
GB
Getting Started
Insert two R6 (size-AA) batteries in the
RM-AAU055 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 28).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
6: Selecting the speaker
system
You can select the speakers you want to drive,
if you have connected the speakers to
SPEAKERS
A and B terminals.
Be sure to use the buttons on the receiver for
this operation.
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the speaker
system you want to drive.
To turn off the speaker output
Press SPEAKERS (OFF/A/B/A+B)
repeatedly until the “SP A” and “SP B”
indicators on the display do not light up.
Note
You cannot switch the speaker system by pressing
SPEAKERS (OFF/A/B/A+B) when the headphones
are connected.
Inserting batteries into the
remote
To select Light up
The speakers connected to the
SPEAKERS A terminals
SP A
The speakers connected to the
SPEAKERS B terminals
SP B
The speakers connected to both the
SPEAKERS A and B terminals
(parallel connection)
SP A
SP B
DISPLAY DIMMER MUTING
TUNING MODE
MEMORY/
ENTER
TUNING BASS TREBLE
SPEAKERS
(OFF/A/B/A+B)
INPUT SELECTOR
FM MODE
PHONES
MASTER VOLUME
SPEAKERS (OFF/A/B/A+B)
